Draining The Engine Oil; Changing The Oil Filter - Nanni N2.10 Notice Et Mode D'emploi

Draining the engine oil

1. Start the engine and let it warm
few minutes so that oil suction is
easier.
2. Stop the engine and remove
the key from the panel.
3. Connect a disposal hose to the
drain pump and place a container
under the disposal hose.
NOTICE: On the engine model
N2.10, the oil pump has to be
connected to the dipstick port.
N2.10
4. Suck out all the oil using the oil
drain pump. Remove the drain
hose and lock the pump.
5. For the N2.10, remove the oil
pump and reinsert the dipstick.
42

Changing the oil filter

Change the oil filter each time the
engine oil is drained.
1. Remove the oil filter with a filter
wrench. Turn the filter counter-
clockwise. Remove the gasket.
2. Clean the mating surface in
order to prevent impurities from
entering the engine.
3. Apply a film of oil on the new
gasket. Screw the new filter by
hand with the new gasket. When
the gasket contacts the mating
surface, turn the filter a half turn.
4. Fill with correct amount of new
oil. Check for leaks and check the
oil level.
5. Start the engine and let it ope-
rate few minutes at idle. Check
that the oil pressure warning lamp
goes out.
6. Stop the engine, wait for the en-
gine to cool down and check the
oil level. Top up if necessary.