Remote Control Transmitter - Panasonic TH-58PF12UK Mode D'emploi

Basic Controls

Remote Control Transmitter

ACTION button
Press to make selections.
ASPECT button
Press to adjust the aspect.
Standby (ON / OFF) button
The Plasma Display must fi rst be plugged
into the wall outlet and turned on at the
power switch (see page 12).
Press this button to turn the Plasma
Display On, from Standby mode. Press
it again to turn the Plasma Display Off to
Standby mode.
POS. /SIZE button
PICTURE button
Sound mute On / Off
Press this button to mute the sound.
Press again to reactivate sound.
Sound is also reactivated when power is
turned off or volume level is changed.
N button
POSITION buttons
INPUT button
Press to select INPUT1, INPUT2, INPUT3
and PC input SLOTS sequentially.
(see page 14)
When a dual input terminal board is
attached, A or B is displayed depending
on the selected input signal.
(Ex. INPUT1A, INPUT1B)
MULTI Window buttons
16
OFF TIMER button
The Plasma Display can be preset to switch to stand-
by after a fi xed period. The setting changes to 30
minutes, 60 minutes, 90 minutes and 0 minutes (off
timer cancelled) each time the button is pressed.
30 60
When three minutes remain, "OFF TIMER 3" will fl ash.
The off timer is cancelled if a power interruption
occurs.
AUTO SETUP button
Automatically adjusts the position/
size of the screen.
SET UP button
SOUND button
Volume Adjustment
Press the Volume Up "+" or Down "–"
button to increase or decrease the
sound volume level.
R button (see page 17)
Press the R button to return to
previous menu screen.
RECALL button
Press the "RECALL" button to
display the current system status.
Input label
1
NANODRIFT setting value
Aspect mode
2
Off timer
3
The off timer indicator is
displayed only when the off
timer has been set.
Clock display
4
4 10:00
Digital Zoom
90
0
PC 1
NANODRIFT HIGH MID
4:3
2
OFF TIMER 90 3