Remote Control Batteries; Vesa Mounting - Panasonic TH-49LFV8U Manuel De Base

Remote Control Batteries

1. Pull and hold the hook, then open the battery cover.
2. Insert batteries - note correct polarity (+ and -).
AAA/R03/UM4 type
3. Replace the cover.
Helpful Hint
●
For frequent remote control users, replace old
batteries with Alkaline batteries for longer life.
Precaution on battery use
Incorrect installation of the batteries can cause battery
leakage and corrosion that will damage the remote
control transmitter.
Disposal of batteries should be in an environment-
friendly manner.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always
use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: "Zinc Carbon"
with "Alkaline")
Do not attempt to charge, short-circuit, disassemble,
4.
heat or burn used batteries.
Battery replacement is necessary when remote
5.
control acts sporadically or stops operating the
Display set
Do not burn or breakup batteries
6.
Batteries must not be exposed to excessive heat
7.
such as sunshine, fire or the like.
10
English

VESA Mounting

To mount this Display to a wall, you will have to obtain a
standard wall-mounting kit (commercially available). We
recommend using a mounting interface that complies
with TUV-GS and/or UL1678 standard in North America.
TH-49LFV8
Table VESA Grid
TH-55LFV8
Table VESA Grid
1. Lay a protective sheet on a table, which was
wrapped around the Display when it was packaged,
beneath the screen surface so as not to scratch the
screen face.
2. Ensure you have all accessories for mounting this
Display (wall mount, ceiling mount, table stand, etc).
3. Follow the instructions that come with the base
mounting kit. Failure to follow correct mounting
procedures could result in damage to the equipment
or injury to the user or installer. Product warranty
does not cover damage caused by improper
installation.
4. For the wall-mounting kit, use M6 mounting screws
(having a length 10 mm longer than the thickness of
the mounting bracket) and tighten them securely.
Protective Sheet
Tabletop stand
Protective Sheet
Tabletop stand