Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
08
Setting up
Selecting a decoder input terminal
If you have connected a decoder, select a decoder input terminal
(INPUT 1).
1
Press HOME MENU.
2
Select "Setup" (/ then ENTER).
3
Select "System Setup" (/ then ENTER).
4
Select "Analogue TV Setup" (/ then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons 0 to 9. For the password, see Using a password on
page 64.
5
Select "Manual Adjust" (/ then ENTER).
6
Select "Programme Entry" (/).
7
Select a programme number (/).
You can select 1 through 99.
After selecting a channel (using Programme Entry), perform the
following steps:
8
Select "Decoder" (/).
9
Select "INPUT 1" (/).
10 Press HOME MENU to exit the menu.
Note
• With "Off" (factory default) selected, you cannot watch any
images from the decoder.
• While watching DTV, no image is output to the decoder.
Labeling TV channels
You can name TV channels that you have set up, using up to eight
characters. This may help you easily identify the channels during
selections.
1
Repeat steps 1 to 4 provided for
terminal .
2
Select "Label" (/ then ENTER).
3
Select "Programme Entry" (/).
4
Select a programme number (/).
You can select 1 through 99.
Programme Entry
Label
5
Select "Label" (/ then ENTER).
The name entry screen appears.
36
En
Selecting a decoder input
:
1
:
12345678
6
Select the first character (/// then ENTER).
K I D S
1 2 3 4 5 6 7 8 9 0
A B C D E F G H
K L M N O P Q R S T
U V W X Y Z
,
&
'
(
)
+
-
*
The cursor moves to the second character.
7
Repeat step 6 to enter up to eight characters.
To correct entered characters, select [] or [] on the screen, and
then press ENTER. The cursor moves to the preceding or
subsequent character.
To delete the current character, select [Delete] on the screen, and
then press ENTER.
To put a space for the current character, select [Space] on the
screen, and then press ENTER.
To toggle between upper case and lower case, select [Caps] on the
screen, and then press ENTER.
To complete the name entry, press / or / to select
8
[OK] on the screen, and then press ENTER.
9
Press HOME MENU to exit the menu.
Note
• The above procedure transfers and sets the selected channel
information to the connected recording equipment such as a
VCR or DVD/HDD recorder (DVR).
Label
I
J
Delete
Space
.
:
;
Caps
/
_ @
OK
Cancel
Publicité
Chapitres
Table des Matières
Dépannage
