Inserting Batteries - FujiFilm instax SQUARE SQ 6 Guide D'utilisation

Inserting Batteries

Caution
• Use two new CR2 lithium batteries. (All the batteries should be new and be the same brand/type.)
• Insert the batteries before you load the instax SQUARE film pack.
• The battery performance may be reduced when it is cold. In this case, warm up the batteries to room temperature
before using this camera.
~
Ÿ
Open the battery lid.
Insert the batteries.
• Insert one CR2
lithium battery
straight (1)
C
matching the
D
and polarities
and slide it to the
end (2).
Then, insert the
other battery.
!
To remove the batteries, remove one battery first, and
then slide the other battery and take it out.
EN
Align the tabs on
the battery cover
and push the battery
cover lock until it
clicks into place.
7