Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Observe the labels screened below the controls for Mono operation.
1.
Master Level Control: Sets the overall level of the entire unit in Mono mode, without changing relative settings
of the individual Sub/Low/Mid/High Outputs. Unity gain for all level controls is "7".
2.
Subwoofer Level Control: Sets the level of signal going to the Sub Output.
3.
Subwoofer Mute Switch: Removes all signal from the Sub Output when pressed to the in position.
4.
Subwoofer Delay Control: In Subwoofer applications this control has virtually no effect and will normally be
set to MIN (minimum).
5.
Sub / Low Crossover Frequency Selector: This selector sets the crossover frequency between the
Subwoofer and Low outputs.
6.
Low Level Control: Sets the Level going to the Low frequency output.
7.
Low Mute Switch: Removes all signal from the Low output when pressed in.
8.
Low Delay Control: Adds from 0 to 2 ms of time delay to the Low output only.
9.
Low / Mid Crossover Frequency Selector: Sets the crossover frequency between the Low and Mid frequency
outputs.
10.
Mid Level Control: Sets the level of signal going to the Mid output only.
11.
Mid Mute Switch: Removes all signal from the Mid output when pressed in.
12.
Mid Delay Control: Adds from 0 to 2 ms of time delay to the Mid frequency output only.
13.
Mid / High-Mid Crossover Frequency Selector: Sets the crossover frequency between the Mid and High-Mid
outputs.
* NOTE: Both the Channel 1 High Level control and Channel 2 Master Level control are automatically bypassed
when the AC 23S is switched to "Mono" on the back panel. Adjusting these controls has no effect in the Mono
mode. The High-Mid Level control, High-Mid Mute switch, High-Mid Delay control and High-Mid / High
Frequency control will have no effect regardless of their settings when the AC 23S is switched to "Mono 4W" on
the back panel.
14.
High-Mid Level Control (5-way only): Sets the level of signal going to the High-Mid output.
15.
High-Mid Mute Switch (5-way only): Removes all signal from the High-Mid output when pressed to the in
position.
16.
High-Mid Delay Control (5-way only): Adds from 0 to 2 ms of time delay to the High-Mid output only.
17.
High-Mid / High Crossover Frequency Selector (5-way only): Sets the crossover frequency between the
High-Mid and High Frequency outputs.
18.
High Level Control: This controls the level of signal to the High output only.
19.
Power Indicator: If the power cable is connected and this yellow LED is lit, then the unit ready to operate.
REAR PANEL: MONO 4-WAY AND MONO 5-WAY CONNECTIONS
8
Publicité
Table des Matières
