Rane AC 23S Guide D'utilisation page 7

REAR PANEL: STEREO 3-WAY CONNECTIONS
Observe the labels above the Inputs and Outputs for Stereo operation.
Channel 1 Input: Plug the left output of the mixer, equalizer, or other source here. Pin 2 is "hot" per AES
1.
standards.
2. Channel 2 Input: Plug the right output of the mixer, equalizer, or other signal source to this Input.
3. High Outputs: Connect the Channel 1 High Out to the left channel input of the high frequency amp, and the
Channel 2 High Out to the right channel input of the high frequency amp.
4. Mid Outputs: Connect the Channel 1 Mid Out to the left channel of the mid frequency amp, and the Channel 2
Mid Out to the right channel of the mid frequency amp.
5. Low Outputs: Connect the Channel 1 and 2 Low Outs to the left and right channels of the low frequency
amplifier, respectively.
6. Stereo / Mono Switch: Set this to the Stereo (out) position.
7. Stereo 2-Way / 3-Way Switches: Set both channels to the 3W position.
8. Mono 4-Way / 5-Way Switch: Set this switch to the 5W position for stereo operation.
9. Power Input: Connect the included power cable here. Do not lift the ground connection!
FRONT PANEL: MONO 4-WAY AND 5-WAY CONFIGURATION
7