Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
higher range of 190 Hz-7 kHz. Set the Channel 1 High Level and the 2 Master Level controls to "7" for unity
gain. Switch Channel 1 to 3W, Channel 2 to 2W, and set the Mono switch to 5W.
1.
Mono Input: Connect the output from your mixer or other signal source only to the Mono 4W / 5W input; do not
use the Channel 2 input. Pin 2 is "hot" per AES standards.
2.
Patch Cable: For this alternate Mono 4W installation, connect a balanced patch cord from the channel 1 High
Out to the Channel 2 input.
3.
Subwoofer Output: Connect the Sub Out to the input of the subwoofer amplifier (or bass bin amp).
4.
Low Output: Connect the Mid Out to the input of the low frequency amplifier.
5.
Mid Output: Connect the High-Mid Out to the input of the mid frequency amplifier.
6.
High Output: Connect the High Out to the input of the high frequency amplifier.
7.
Stereo-Mono Switch: Be sure this switch is in the Stereo (out) position. A Mono circuit is created when
Channel 1 is patched into Channel 2, and the correct signal flow depends on this switch.
8.
Stereo 2-Way / 3-Way Switches: For this configuration, set Channel 1 to 3W, and Channel 2 to 2W.
9.
Mono 4-Way / 5-Way Switch: Be sure this switch is is in the 5W position.
10.
Power Input: Connect the included power cable here. Do not lift the ground connection!
10
Publicité
Table des Matières
