Installation And Connection - Bartscher A150.670 Mode D'emploi

•
Do not use the device in case it does not function properly, has been damaged or
dropped.
•
Do not use any accessory or spare parts that have not been recommended by the
manufacturer. These can be dangerous for the user or lead to damages of the
device or personal injury, and further, the warranty expires.
•
Do not lay the cable over carpets or heat insulations. Do not cover the cable. Keep
away the cable from operating range and do not dunk it into water.
•
Do not move or tilt the device when in operation.
•
In case of thunderstorms and similar, disconnect the device from the mains
immediately! This prevents damage to the device by lightning.
CAUTION! Risk of injury!
Never remove the casing and never modify the degvice yourself! Modifying the
device may lead to sever damage to persons and objects!
WARNING! Hazard via electrical current!
The device can cause injuries due to improper installation!
Before installation the local power grid specification should be compared with that
of the device (see type label).
Connect the device only in case of compliance!
Take note of the security advice!

5.2 Installation and connection

CAUTION!
The installation and maintenance of the device should only be carried out by
trained personnel!
•
Discard the complete packing material after unpacking the device.
•
Remove the protective film from the unit. If any glue remains, remove it with an
appropriate solvent.
•
Place the device on top of an even and safe surface which supports the weight of the
device and is not heat sensitive.
•
Not at any time should you place the device on an inflammable surface (such as:
table cloth, carpet, etc.).
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
- 23 -