Operating - Bartscher A150.670 Mode D'emploi

•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
unit directly to the wall socket; do not use any extension cords or power strips.
•
Place the unit so that the plug is easily accessible and can be quickly removed from
its socket in case of necessity.
•
There is a ground pin on the back of the device. Please connect the earth cable with
a copper cable (diameter at least 2 mm²) in conformity with the valid general safety
regulations.
•
The double grill shall be connected to two separate network sockets.

5.3 Operating

•
Connect the device to a single outlet.
•
A green network connection indicator light is on.
•
The device is equipped with a temperature control knob. The adjustable temperature
is between 50° -300° C. We recommend maintaining the maximum operating
temperature between 200° -250° C.
•
A red temperature indicator light turns on in the moment of setting the temperature
regulation knob on the desired value.
•
After turning the device on, it need approx. 10 minutes to reach the temperature of
250° C.
•
When the device reaches the desired temperature, the red temperature indicator light
turns off.
•
If the temperature falls down for about. 10° C, the heating is turned on again and the
red temperature indicator light turns on.
•
Now lift the top grill with the handle to an adequate position. Pour a bit of vegetable
oil onto the bottom grill and add the food. Close the grill halves. Keep an eye on the
food until it is done cooking.
WARNING! Hot surface!
The contact grill gets very hot during operation, also on the sides and the top.
Never touch the device during operation or shortly after!
Never operate the device in a slanted position!
•
There is a fat receptacle on the front of the bottom grill, which catches the draining
fat. Wait until the device, the receptacle and the content have cooled off to drain it.
- 24 -