Crock-Pot CSC051X Notice D'utilisation page 15

Figure 3
Note: Never use metal utensils or cleaning devices on the Cooking Pot, as this may result in scratching and damaging the
non-stick coating.
Exterior
Wipe the exterior of the Heating Base with a damp cloth and polish dry. DO NOT use harsh abrasives, scourers or
chemicals, as these will damage the surfaces. To prevent damage to the Multi-Cooker do not use alkaline cleaning agents
when cleaning. Only use a soft cloth and mild detergent. Never immerse the heating base, or power cord and plug in water
or any other liquid.
Condensation Collector
Empty any collected water from the Condensation Collector after each use. Wash in warm, soapy water.
Lid and Sealing Gasket
Always examine the gasket before each use. The silicon Sealing Gasket on the inside of your Multi-Cooker Lid may
deteriorate over time. Remove Sealing Gasket for cleaning as needed. Hand clean using warm, soapy water, dry
thoroughly, and replace Sealing Gasket in Lid before use. Leave the Lid upturned for storage, as this will also extend the
life of the gasket. Sealing Gasket may need to be replaced every 1 – 2 years depending on regular use. Contact Crock-Pot
®
customer service to order replacement parts.
Steam Release Valve
Ensure the Steam Release Valve is clear from debris before you begin using the Multi-Cooker. Remove the valve and
gently clean. Ensure it is completely dry before replacing.
Steam Release Valve Cover
The Steam Release Valve Cover is on the underside of the Lid. Ensure it is clear from debris before you begin using the
Multi-Cooker. To clean, carefully pull the cover off and clean using warm, soapy water. Press the cover back into its place
after cleaning is complete.
Bobber Valve
Steam Release Valve Cover
Figure 4
UNDERSIDE OF LID
Bobber Valve
Gently press the valve up and down 2-3 times and ensure it is clear from debris before you begin using the Multi-Cooker.
15