Maintenance Instructions - Altrad Belle PREMIER XT Manuel De L'opérateur

Table des Matières

Les langues disponibles

Before starting any maintenance or repairs, stop engine or switch off motor, and isolate from the main power supply.

On completion of maintenance, check that the mixer functions correctly and that all guards are correctly tted.

ELECTRIC MOTORS

All portable electric appliances are dangerous if abused. This machine will only operate on one voltage. Check the power supply to

ensure it corresponds to the voltage as stamped on the motor. Make sure that the motor is switched off before you plug it into the

power supply.

220-240v -Always use a Residual Current Device ("RCD"), (earth leakage trip), plugged directly into the 220-240v socket. If using an

extension cable, plug it directly into the RCD.

110v -When using a portable transformer it must have a minimum output of 6.3kw and be continuously rated.

DO NOT use an extension cable between the transformer and the power supply.

The symbols on the ON/OFF switch are 0=OFF and I=ON in accordance with international standards.

If the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its

service agent. (See Wiring Diagram on Page 15.)

EXTENSION CABLES

If you need to use an extension cable it must be no longer than 30 metres (100 feet) in length. The wire section for 220-240v must be

2.5mm

. The wire section for 110v must be 4mm2 on 100XT and 6mm2 on other models. Ensure that the extension cable is

carefully laid out avoiding liquids, sharp edges and places where vehicles might run over it. Unroll it fully or it will overheat and could

catch re. Make sure that any extension cable connections are dry and safe.

COMBUSTION ENGINES

Be aware of exhaust venting directions.

ENGINE OIL

The engine needs a regular oil check.Try not to run low on fuel as this may result in sediment from the bottom of the tank doing

damage to the injector and pump. Repairs and recti cation of pipework and components affected by contaminants in fuel

cannot be accepted as warranty, neither will faults caused or contributed to by the machine running out of fuel. You may

need to bleed the fuel system free of air before starting. Select the appropriate engine oil viscosity based on the ambient temperature

and use the SAE Service Grade Viscosity Chart below. This machine is lled with SAE 10W-30 at the factory.

Engine Oil Speci cations

Use an engine oil that meets or exceeds the following guidelines

and classi cations:

Service Categories

API Service Categories CD or higher.

ACEA Service Categories E-3, E-4 and E-5

JASO Service Category DH-1

De nitions

API Classi cation (American Petroleum Institute)

ACEA Classi cation (Association des Constructeurs Européens

d'automobilies)

JASO (Japanese Automobile Standards Organisation)

DRUM (Removal and Fitment)

This can be instantly removed by unscrewing it counter clockwise in the vertically up position. Lift the drum off the machine using a

fork lift, with the forks under the base of the drum. When replacing make sure that the drum shaft is greased before it is fully

screwed down on to the shoulder of the shaft, ensure the drum is fully screwed down on to the shoulder or damage will occur. Take

care when screwing on the drum, spinning on fast may damage the gearbox.

CLEANING

Wipe off any external material. DO NOT use petrol, turpentine, lacquer or paint thinner, dry cleaning uids or similar products. Never

let any liquids near the engine/motor. Use 1" gravel and clean water to clean the inside of the drum.

DO NOT use bricks etc. as this will damage the drum.