Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Before starting the mixer
•
Note:
•
•
DO NOT wear loose clothing or jewellery that may become entangled in the workings of this machine.
•
Suitable clothing as follows should meet relevant EEC/local safety standards: overalls, work boots, goggles, face mask, gloves
and ear defenders etc.
•
DO NOT tip mixer onto the drum mouth when motor is running.
•
Ensure that any trailing cable is protected against damage and not liable to be tripped over or trapped underneath the mixer.
•
We recommend the use of an Residual Current Device on 230v electrics.
•
Remove all packaging material before operating.
When operating the mixer
•
Keep unauthorised persons away from mixing drum.
•
Keep area around the mixer clear of obstructions which could cause persons to fall onto moving parts.
•
Always ensure mixer is on level ground before mixing.
•
DO become familiar with the controls before operating this machine.
•
DO
•
DO
•
DO replace any worn/damaged warning decals.
•
DO ensure the drum is rotating while emptying the mixer.
•
DO
•
DO NOT use as a wheel barrow. Disconnect from power supply before moving.
•
DO NOT leave the mixer in the 'discharge' position, whilst the engine is still running, for more than 2 minutes.
•
BEWARE of the Danger Zones & Hot Zones.
•
BE AWARE of exhaust venting directions.
Emergency Stop
Fire Fighting
Belle authorized Service Dealer.
Warning - Important
BLUE = NEUTRAL & BROWN = LIVE
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the
terminals in your plug, proceed as follows:
The wire which is coloured Blue must be connected to the terminal which is is marked with the letter N or coloured Black. The wire
which is coloured Brown must be connected to the terminal which is is marked with the letter L or coloured Red.
Safety Instructions
13
GB
Publicité
Chapitres
Table des Matières
