Getting Ready For Use - Kodak SMILE Classic Guide De L'utilisateur

Charging
indicator LED
indicator LED
Reset button
Micro USB microSD™
port port
Carrying strap
attachment
8 | EN
microSD™
Power indicator LED
Power latch

GETTING READY FOR USE

1. Charge it first: Before you start using your new KODAK SMILE
Classic camera, plug it in to your computer or any USB charging
block with an output of two amps (2A) or higher. The charging
indicator will flash white while the camera charges. Once it turns
solid white and stops flashing, it's fully charged and ready to use.
2. Load your ZINK® paper into the camera: Follow the steps below to
quickly and easily get your new camera loaded with ZINK® sticky-
back paper so you can start printing photos!
a. Open the paper tray in the back by releasing the tray cover at
the rear of the device. Press down on the arrow and slide the
cover toward you.
b. Load the blue calibration sheet in with the barcode facing
down. Place the other plain sheets on top with the glossy side
facing you. Try to avoid touching the glossy side so you don't
get fingerprints on it.
EN | 9