Preface; Introduction; Safety - Simco-Ion ThunderION Notice D'utilisation

USER MANUAL FOR THUNDERION CONTROL MODULE

Preface

Read through the whole manual before you install and commission the product.
Follow the instructions set out in this manual to ensure proper operation of the product and to
retain your entitlement under the guarantee.
The term Control Module in this user manual refers to the ThunderION Control Module.
The terms of the guarantee are set out in the SIMCO (Nederland) B.V. General Terms and
Conditions of Sale.

1. Introduction

The Control Module forms, together with connected ThunderION anti-static bars, a system for
neutralising static electricity.
The Control Module has a switched power supply that converts mains voltage to 24 V DC to
operate a maximum of 4 ThunderION units.
LEDs on the Control Module show whether the ThunderION is switched on and whether a fault
has occurred.
The ThunderION incorporates functions for being switched on and off remotely, as well as for
remote read out of high voltage (not wireless).

2. Safety

 The Control Module is only meant for use with the ThunderION.
 Read the ThunderION user manual as well as this user manual.
 Electrical installation, maintenance and repairs may only be carried out by a skilled electrical
fitter.
 Before working on the equipment, disconnect the power supply.
 Ensure that the equipment is properly earthed (see Installation, H4).
Equipment must be earthed to ensure that it works properly and safely.
 The Control Module is protected against overload by a glass fuse.
 If changes, adjustments etc. have been made without prior consent in writing, or if non-
original parts have been used for repairs, the equipment loses its CE approval and will no
longer be under guarantee.
ControlModuleThunderION_UM_9752160020_NL_D_GB_F_V1_1 22