Trebs 99279 Mode D'emploi page 24

NOTE:
When you remove the jug from the base following operation, the button with the
flash. Once you have set the jug back onto the base, the flashing will stop.
5.4 Capacity
The jug holds between 250 and 450 ml.
Frothing milk
Install the foam blender (9).
CAUTION:
Observe the capacity marking MAX, otherwise the milk will foam over.
NOTE:
• For optimum results use milk with 3.5% fat content and fill in 225 ml.
• Milk with 1.5% fat content and soy milk or lactose-free milk does not froth as well.
Heating up drinking chocolate
Install the hot milk blender (10).
CAUTION:
• Only add the cocoa powder after the milk, otherwise the mixing attachment will clog up otherwise.
• Do not fill above the MAX mark, otherwise the beverage will overflow.
5.5 Operation
Use a mixing attachment and the function key for the application according to the following table.
Aim
Frothed milk
Heated milk or hot
chocolate
Hot liquids, e.g. sauces
Cold frothed liquids
Cold stirred liquids
1. Fit a mixing attachment.
2. Fill the liquid into the jug.
3. Put on the lid.
4. Press a function key.
5. Either wait for the automatic shut-off or press the function key again to cancel the operation.
6. If you want to end the operation, disconnect the mains plug.
6 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining the device.
Please observe the notices to prevent damages due to cleaning the device incorrectly and to ensure
trouble-free operation.
6.1 Safety information
Application Button
9
10
10
9
10
24
symbol will