GBC FUSION 1000L Manuel D'utilisation page 6

GB
getting ready to laminate
Easy Set Up
1 Take the electrical plug and place in an appropriate power source, which is near the table you
intend to use.
2 To use the laminator move the slider to the right from the '
the slider you will see a white line, this indicates that you have switched the laminator on.
NOTE: Only use 75 micron/
80 micron pouches
Visual Ready Alert
3 The laminator will start to warm up. When the laminator is ready to use the green light next to the
'tick ' is illuminated.
NOTE: Your new laminator may emit
a slight odour during the initial
operation. Its is normal and will
diminish after a few hours of
operation.
loading the pouch
1 Take your item to be laminated and place in to the appropriate sized laminating pouch,
ensuring it is firmly located along the sealed edge. This is to help ensure that you get optimal
quality output.
NOTE: Do not cut pouches prior to
lamination.
Before laminating important or unique documents, always run a test pouch through
the laminator using a similar type document.
6
register this product online at www.accoeurope.com
' to the '75 micron' position. Below
SEALED EDGE
A3, A4, A5, etc.
SEALED EDGE
Irregular shaped item