Flex FX4111 Manuel De L'utilisateur page 14

LED WORK LIGHT (FIG. 12)
Fig. 12
Your tool is equipped with an LED work light.
This work light provides additional light on the
surface of the workpiece for operation in lower-
light areas.
The work light will automatically turn on
when the tool is turned on and will turn off
approximately 10 seconds after the tool is
turned off.
The work light will rapidly flash when the tool
and/or battery pack becomes overloaded or too
hot.
The internal sensors will turn the tool off if the
tool and/or battery pack are overloaded. Rest
the tool for a while or place the tool and battery LED Work light
pack separately under air flow to cool them.
The work light will flash more slowly to indicate
that the battery is at low-battery capacity.
Recharge the battery pack.
If the work light fails to light up when you switch
the tool on, or it turns off suddenly during
operation, please contact customer service or
an authorized service center for assistance.
-14-