Flex FX4111 Manuel De L'utilisateur page 12

SETTING THE SPEED (FIG. 10)
There are five speed levels that can be changed
using the speed setting buttons. Press the "︿"
button to increase the speed. Press "﹀" button
to decrease the speed. The LED lights above
the numbers indicate the current speed level.
The speed level can be set before the tool
is turned on or when the tool is already in
operation.
The approximate OPM (oscillations per minute)
are:
Speed Level
1
2
3
4
5
If the tool is OFF:
a. Press one of the speed setting buttons. This
will "wake up" the control panel and the LED
lights will indicate the current speed level.
b. Change the speed level by pressing the " ︿ "
or " ﹀ " buttons.
c. After ~15 seconds of inactivity the LED lights
on the control panel will turn off. The memory
function will remember and revert to the last
active speed level the next time one of the
speed setting buttons is pressed or the tool is
turned on.
If the tool is already ON:
a. Change the speed level by pressing the " ︿ "
or " ﹀ " buttons. You will feel and hear the
speed change and the LED lights will indicate
the current speed level.
b. After you turn the tool off, the memory function
will remember and revert to the last active
speed level the next time the tool is turned on.
WARNING
tool is running at no-load. Make sure to hold
the tool firmly within the soft grip area with one
hand, keeping the tool under control, when
adjusting the speed when running at no-load.
Failure to obey this caution could cause loss of
control and result in serious personal damage.
ADJUSTMENTS
/min (OPM)
10000
12000
15000
18000
20000
Adjust the speed only when
the tool is off or when the
Fig. 10
-12-
Speed Setting Buttons
Speed Control Panel