Flex FX4111 Manuel De L'utilisateur page 10

b. Continue to turn the lever counterclockwise
(this time you will feel some resistance) as
far as it will go, which will be indicated by
the second "click". The clamping jaws of the
accessory holder are now closed and the new
accessory can be installed (Fig. 4).
Place the accessory on a flat surface. Grasp
the machine body with one hand and the
accessory release lever with another hand.
Align the star-shaped interfaces of the
accessory holder with the accessory
(Fig. 5 & 6).
Note that the accessory can be positioned at
various angles if desired (Fig. 5).
c. Turn the accessory release lever clockwise
to return it to its original position (Fig. 3). The
clamping jaws of the accessory holder will
open and lock the accessory in place.
WARNING
that they face backward. Operation in this
position may cause serious injury (Fig. 7).
To remove the accessory
Make sure that the On/Off switch is in the OFF
position and detach the battery pack from the
tool.
a. Turn the accessory release lever on the head
of the tool counterclockwise past the first
"click" which signals that the lever has been
engaged (Fig. 4).
b. Continue to turn the lever counterclockwise
(this time you will feel some resistance) as
far as it will go, which will be indicated by the
second "click" (Fig. 4). The clamping jaws
of the accessory holder will close and the
accessory will fall out of the accessory holder.
Do not attach the
accessories in such a way
Fig. 4
Accessory
Release Lever
Fig. 5
Fig. 6
Fig. 7
-10-