Shutting Down The Device; Routine Maintenance / Sterilization; Contra-Angle Maintenance; Rotary Instrument Maintenance - Satelec Acteon I-Endo Dual Manuel D'utilisation

Attach the appropriate "E-Type" handpiece to the motor. It can be used with most endodontic contra-
angles without internal light or spray on the market.

Place the micro motor on the motor holder.
- Footswitch connection:

Connect the footswitch into the receptacle on the front of the central unit ( Left – Blue
– 5 Pins )

Place the footswitch on the ground.
While inserting the plug, align the guide on the connector in an upright position to fit
into the corresponding female guide on the I-Endo Dual (Fig. 13). Connectors have a
spring retention system to help avoid accidentally disconnecting the unit's cords and
cables.
- Switch on the device:
Electrical connections
VII – SHUTTING DOWN THE DEVICE
Upon completion of the dental procedure:
- Remove the instrument fastened to the contra-angle.
- Disconnect the contra-angle from the I-Endo Dual micro-motor.
- Disconnect the micro-motor cord from the I-Endo Dual unit.
- Switch the device off (O).
VIII – ROUTINE MAINTENANCE / STERILIZATION
Important:
The I-Endo Dual micro-motor and cord is not autoclavable.

8.1 CONTRA-ANGLE MAINTENANCE

Refer to the manufacturer's instructions for your contra-angle.

8.2 ROTARY INSTRUMENT MAINTENANCE

Please refer to the manufacturer's instructions for your instruments (file).

Use only contra-angle that conform to ISO 3964.

Change the contra-angle only when the motor not running.

Check the voltage present on your power line (100VAC to 240VAC).

Connect the power cord to I-Endo Dual by inserting the female
connector of the power supply into the male receptacle on the back of
the unit.

Connect the power supply into the electrical outlet.
16