F+R Mode - Satelec Acteon I-Endo Dual Manuel D'utilisation

NB:
Beeping sound notifies user when 75% of the preset torque has been reached and when preset
torque limit has been exceeded.
b. F+R mode
In every program has been set the same information by the manufacturer (Fig. 12):

Ratio: 16:1

Rpm: 250 rpm

Angle in FWD: 170°

Angle in REV: 70°
The listed parameters are only examples. To prevent unnecessary risk, observe the
guideline speeds given by the manufacturer of the rotating instruments and the
guideline given by the manufacturer of the contra-angle in use.
The first row shows the:

MODE in use: F+R / Rotating
The second row shows the:

Program in use.
Scroll programs with "P" button
The third row shows the:

Speed in use (left)
Change speed with "RPM" button

Value of the angle in FWD° (right)
Change value of the Angle in FWD with "FWD°" button
The fourth row shows the:

Contra-angle reduction rate.
Change contra-angle reduction rate with "Ratio" button.

Value of the angle in REV° (right)
Change value of the Angle in REV with "REV°" button

Programming the unit:
1. RATIO: Sets handpiece reduction ratio. See the available reduction ratio in the following
table:
1:1
Always check the values before use. Danger of injury for incorrect use.
6:1 16:1 20:1 32:1
14