On Floor - arjo MAA4031M Mode D'emploi

In Chair/ Wheelchair (24 steps)
Prepare the patient for transfer by loosening the
Stand in front of the patient and lean the patient
Place the inside of the sling against the patients
EN
needed, use an Arjo sliding sheet/tube for placing
the sling See respective Sliding sheet/tube IFU
Make sure that the centre line is aligned with the
Attach the support belt around the patient's
Make sure that the:
•
• sling's head support covers the neck/head area,
• sling pieces are not twisted underneath the
patient and
•
Place the lift in front of the patient and open the lift
WARNING
To avoid injury to the patient, pay close
attention when lowering or adjusting the
spreader bar.
Attach the sling, start with the midsection and then
• If using a loop sling, attach the loops in a more
• If using a clip sling, position the DPS
(Dynamic Positioning System) in a seated
(See Fig. 12 )
Fig. 12
WARNING
Make sure straps are not caught by
wheelchair or lift castors.
Slightly lift the patient to create tension in the
(See Fig. 12 )
WARNING
To avoid the patient from falling, make sure
that the sling attachments are attached
securely before and during the lifting
process.
Make sure that:
• All clips/loops are securely attached
(See Fig. 4 ) and (See Fig. 6 )
• All straps are straight (not twisted)
•
If an adjustment is needed, lower the patient and
make sure that the weight of the patient is taken up
by the receiving surface before removing the clip/
Attach the neck buckle to midsection of sling, if
WARNING
To avoid injury, always make sure the sling
is attached correctly.
lift IFU
Slightly push the sling/straps and not the patient,
IFU (See Fig. 13 )

On Floor

Toilet sling
Fig. 13
10