Clip Attachment & Detachment; Loop Attachment & Detachment - arjo MAA4031M Mode D'emploi

Clip Attachment & Detachment
NOTE
If available on your lift device, reposition the
spreader bar using the Dynamic Position
sling. See lift IFU for instructions.
Attach the Clips (5 steps)
EN
Make sure the lug is locked at the top end of the
(See Fig. 4 )
Loop Attachment & Detachment
2 point spreader bar:
4 point spreader bar:
back hooks
WARNING
Do not cross the shoulder straps.
Attach the Loops (5 Steps)
WARNING
Use the same loop length (loop colour) for
the shoulder straps and the same length
(loop colour) for the leg straps.
Place the loop over the spring loaded latch (A
(See Fig. 6 )
Make sure that the spring loaded latch closes
Fig. 3
Fig. 6
(See Fig. 3 )
(See Fig. 6 )
Fig. 4
Fig. 7
A
Make sure the strap is not squeezed in between the
Detach the Clips (3 steps)
Make sure that the weight of the patient is taken up by
(See Fig. 5 )
Make sure the lug is unlocked at the bottom of the
NOTE
The loops lengths on the straps are used to
adjust the patient's position and comfort.
• Loops closer to the shoulders;
more forward position
• Loops further away from the shoulders;
more reclined position
• Loops closer to the legs;
raised legs/bottom
• Loops further away from legs;
lowered legs/bottom
Detach the Loops (2 steps)
Make sure that the weight of the patient is taken up by
Method 1
Method 2
Pull one side of the loop over the hook and spring
(See Fig. 7 )
Fig. 8
8
(See Fig. 8 )
Fig. 5