Information / Error Diagnosis - Virax 575002 VULCA VIWEL + 400 Manuel D'utilisation

The device saves up to 2,000 welding sequences automatically. If the 2,000 memory places are filled up
the device displays an appropriate warning on the Start screen. A further 47 welding sequences are stored
in the overflow memory.
Attention! Loss of data can occur in both cases if a welding sequence is performed despite a full
memory. We recommend backing up the logs in good time using a USB stick and clearing the
device memory regularly.
Password
This is where the password for the protected area "Parameter" can be altered. Press the >CHANGE<
button to change the password. The change takes place manually (see also the Chapter "Data entry").
Maintenance
Password-protected area (excluding VIRAX service personnel).
Contrast
The contrast of the display can be adapted here to the environmental conditions. The contrast can be
altered using the arrow keys >+< and >-<. The sub-menu can be exited again using the >< button.

8 Information / Error Diagnosis

Press the multi-function key >INFO< on the Start screen.
The following information is displayed:
Product ............................. Name of the product
Serialnumber .................... Serial number of the device
Typecode .......................... Type code (type of bar codes) according to ISO 12176-2
Owner ............................... Owner of the device (see Section 7.5)
Software ........................... Software running
Total Log Counter ............. Number of all previously performed welding sequences performed during the
for example: P24US2VAKDX
service life of the device
Page 29