Performance Of A Welding Sequence - Virax 575002 VULCA VIWEL + 400 Manuel D'utilisation

Manual Input of numbers
If only numbers are needed for the data entry (e.g. manual entry of the scan fitting code), then only the
numbers from 0 to 9 are offered for selection. The numbers can be selected using the > + < and > - <
buttons. The >  < and >  < buttons are used to locate the individual numbers. After entry of the last
number, also confirm this by pressing the >< button.

7.3 Performance of a welding sequence

Press the multi-function key >WELDING< on the Start screen.
The required data for welding can be entered under the menu point >WELDING<. A barcode can be read
in for this using the barcode scanner or, otherwise, data can also be entered manually using the multi-
function keys.
Input Welder Name
If the option "Welder code" is deactivated the name of the welder can be entered at this point. Entry can
be either manually or through use of the barcode. The "Welder name" is a freely entered name consisting
of up to 30 digits. Entry can be sprung over using the > OK < button. If the option "Welder code" is
activated, the "Welder name" is not additionally queried.
Welder code
If the option "Welder code" is activated in the parameters (see Section 7.5 "SETUP"), then a valid welder
code must be entered at this point (only an ISO-standard compliant welder code will be accepted by the
device).
Scan Site-Code
This entry can be made either through use of the barcode scanner or manually or can also be skipped
over by using the >OK< button and thus remains empty.
Date
The current date and time and ambient temperature are displayed here.
Environmental Condition
If the option "Environmental condition" is activated (see Section 7.5 „SETUP"), then the environmental
conditions at the point in time of the welding (sunny, dry, rain, wind, time, heating) should be entered at
this point.
Page 24