Transfer Of The Stored Welding Protocol; Configuration Of The Device ("Setup") - Virax 575002 VULCA VIWEL + 400 Manuel D'utilisation

If the welding is faulty, the message "Error" appears in the display. An acoustic and a visual signal in the
form of a red flashing LED is issued.
A new data entry can be started using the ><.

7.4 Transfer of the stored welding protocol

Press the multi-function key >USB< on the Start screen.
The logs can be transferred from the internal memory of the device to a USB memory medium using the
"USB" menu point.
Insert a USB stick into the USB connector. Wait until the storage medium was successfully recognized
(detection time may vary depending the USB stick). If the USB stick has a name, it will appear on the
screen. Upon actuation of the >Start< button all logs stored in the device are transferred the USB stick.
The device creates a new directory with the name "VIWEL" on the USB stick. In a sub-directory of
"VIWEL", a further directory is created with the serial number of the device as a name. The logs are stored
in this directory.
The logs can be managed using the read out software VIDATA 2.0 and also further processed (Section 9).

7.5 Configuration of the device ("SETUP")

Press the multi-function key >SETUP< on the Start screen.
The desired menu point can be selected using the two central up and down arrows and confirmed using
the >  < button.
The >  < button allows one to leave this menu and navigate back to the Start screen.
Clock
Page 27