Dual Control; Dual Control Movement; Dual Control Movement Protocol - Chauvet Professional Maverick Storm 1 Wash Manuel D'utilisation

Dual Control

In Dual Control mode, the Maverick Storm 1 Wash is controlled by two protocol inputs. One controls the
movement of the yoke and zoom, and the dimmers and shutter, whereas the other controls the individual
LED output.

Dual Control Movement

The Movement protocol controls the movement of the yoke and zoom, and the dimmers and shutter.
Choose from DMX, Art-Net™, or sACN. In this mode, the three personalities available are: Basic (8
channels), Standard (20 channels), and Advanced (26 channels).

Dual Control Movement Protocol

To select the Dual Control Movement protocol, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Control Settings.
3. Press <ENTER>.
4. Use <UP> or <DOWN> to select Dual Control.
5. Press <ENTER>.
6. Use <UP> or <DOWN> to select Movement.
7. Press <ENTER>.
8. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from DMX, ArtNet, or sACN.
9. Press <ENTER>.
Dual Control Movement Personality
To select the Dual Control Movement personality, set the Protocol, then do the following:
1. Use <UP> or <DOWN> to select Personality.
2. Press <ENTER>.
3. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from Basic (8-channel), Standard (20-
channel), or Advanced (26-channel).
4. Press <ENTER>.
Dual Control Movement Start Address
To set the starting address of the Dual Control Movement mode, set the Protocol, then follow the
instructions below:
1. Use <UP> or <DOWN> to select Start Address.
2. Press <ENTER>.
3. Enter the starting address (1–512) with one of the following methods:
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Dual Control Movement Universe
To set the Universe address of the Dual Control Movement mode when using Art-Net™ or sACN, set the
Protocol to ArtNet or sACN, then do the following:
1. Use <UP> or <DOWN> to select Universe.
2. Press <ENTER>.
3. Enter the universe address (0–255 for Art-Net™, 1–256 for sACN,) with one of the following
methods:
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Page 15 of 306
Home Screen shows on the display. Press <ENTER>.
Maverick Storm 1 Wash User Manual Rev. 2
Operation