Makita M8100 Manuel D'instructions page 5

MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
• Never use gasoline, benzine, thinner, alcohol or the
like. Discoloration, deformation or cracks may result.
To maintain product safety and reliability, repairs,
maintenance or adjustment should be carried out by a
Makita Authorized Service Center.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (
Sound power level (
Uncertainty (K): 3 dB (A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode: impact drilling into concrete
Vibration emission (
Uncertainty (K): 2.0 m/s
Work mode: drilling into metal
Vibration emission (
Uncertainty (K): 1.5 m/s
• The declared vibration emission value has been
measured in accordance with the standard test method
and may be used for comparing one tool with another.
• The declared vibration emission value may also be
used in a preliminary assessment of exposure.
WARNING:
• The vibration emission during actual use of the power
tool can differ from the declared emission value
depending on the ways in which the tool is used.
• Be sure to identify safety measures to protect the
operator that are based on an estimation of exposure in
the actual conditions of use (taking account of all parts
of the operating cycle such as the times when the tool
is switched off and when it is running idle in addition to
the trigger time).
): 98 dB (A)
L
pA
): 109 dB (A)
L
WA
2
): 16.5 m/s
a
h, ID
2
2
): 3.0 m/s
a
h, D
2
For European countries only
EC Declaration of Conformity
Makita declares that the following Machine(s):
Designation of Machine:
Hammer Drill
Model No./ Type: M8100, M8101
Conforms to the following European Directives:
2006/42/EC
ENG905-1
They are manufactured in accordance with the following
standard or standardized documents:
EN60745
The technical file in accordance with 2006/42/EC is
available from:
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
ENG900-1
Makita, Jan-Baptist Vinkstraat 2, 3070, Belgium
ENG901-1
1.12.2014
Yasushi Fukaya
Director
ENH101-18
5