About The Battery Pack - Tivoli Audio MUSIC SYSTEM THREE Mode D'emploi

Pairing A Bluetooth Wireless Technology Enabled
iPhone/iPod Touch/iPad
1. Press the Music System Three's front panel Bluetooth button or change the source to
Bluetooth. This will power on the Bluetooth. Turn the volume up about ¼ to start. Also
turn up the volume on the source device (the device you are streaming from).
2. Select "Settings" (depending on software version).
3. Select "General".
4. Select "Bluetooth".
5. Switch Bluetooth "On" to initiate searching.
6. Select "Tivoli Bluetooth (Not Paired)" when it appears on the display. If you are
prompted to enter a PIN, enter "0000". "Tivoli Bluetooth" will change from "Not Paired"
to "Connected".
7. You will hear a ring tone from the Music System Three and you can begin playing your
music files wirelessly. Adjust the volume level on your device. You should not have to pair
your iPhone/iPod/iPad again.
The volume output level of music files varies. If you prefer an even higher output level, check
the settings in your iPhone/iPod touch/iPad: Set the EQ Off, the SoundCheck Off, and the
Volume limit Off.
If you encounter a problem Pairing, press the small arrow to the right of "Tivoli Bluetooth" on
your iPhone/iPod touch/iPad display and select "Forget this Device", then repeat the Pairing
process. Depending on your device, you may need to make multiple attempts at Pairing
and/or Connecting to the Music System Three, but please give your device adequate
time to Pair or Connect before repeating the process.
When streaming music, you can press the blue arrow to the right of the next track button >>/ on
the iPhone/iPod touch/iPad display to alternate between the iPhone/iPod/iPad and Bluetooth.
NOTE:
• The Music System Three will remember pairing information for up to 8 devices. Ad-
ditional devices can be paired, but the least-recently used device will be replaced by
the newly paired device.
• If the audio drops out or stops during playback, move your device closer to the Mu-
sic System Three, or check to be sure another wireless device is not interfering with
the signal.
• When switching from Bluetooth to AM or FM, you may need to re-adjust (lower) the
radio's volume level.

About the Battery Pack

The installed Li-Ion battery pack is partially charged. To charge the battery pack, con-
nect the provided external power supply to the radio and plug it in. A full charge will take
approximately 12 hours, while 2-3 hours will provide about a 75% charge. The display will
show the charging/battery status only when operating on battery power.
Battery almost empty, please charge
2/3 charged
14 – ENGLISH
1/3 charged
Fully charged