VINCENT CD-200 Manuel D'utilisation page 34

This device is equipped with a switch (15) that can be used to change the country-specific voltage from
230 V to 110 V.
Please never actuate the switch during operation! The voltage must only be switched by a techni-
cian, since the device fuse must also be replaced after actuation of the switch! Information about
the device fuse can be found on the back of the device.
Unauthorised actuation of the switch will void any warranty claim!
CONNECTIONS FOR THE STANDBY CONTROL
Many AV systems or stereo audio systems consist
of a multitude of individual components. To avoid
the necessity of switching them on and off before
and after every use, many manufacturers have
equipped their devices with what is known as
"POWER CONTROL" circuit or "TRIGGER". This
kind of remote-controlled standby circuit is used
primarily for preamplifier and power amplifiers. To
employ these functions, direct or indirect cable
connections must be made between the preampli-
fier (or integrated amplifier) and all the devices
which support this function. The "POWER CON-
TROL" function operates in such a way that each
switching on or off of one device in the system (usu-
ally the preamplifier) automatically brings about
the switching on or off of all the connected devices
Vincent
34
SWITCHING THE VOLT GE
(POWER CONTROL)
which support this function. Please keep in mind
that all devices which respond to the power control
are not disconnected from the mains network when
switched off. They are set to a standby state instead.
For connecting cables, two-core cables with 3.5 mm
jack plugs (mono) are used. For each connection bet-
ween two devices one of those cables is needed.
If the CD-200 is to be switched on/off automatical-
ly with the preamplifier or integrated amplifier,
then the cable connections for power control des-
cribed below must be made correctly and the
"POWER" switch (4) must be moved to the swit-
ched off position. If you don't wish to use this
function or if the other components do not support
it, all you have to do is leave out these cable con-
nections.