VINCENT CD-200 Manuel D'utilisation page 28

13
13. AUDIO OUTPUTS:
analogue audio signal outputs
Either the RCA or the XLR sockets are connected
to the relevant input of the amplifier, preamplifier
etc. It is not necessary to also connect the digital
signal output (16).
14. DIGITAL OUT COAXIAL:
digital audio signal output
If the amplifier, receiver or preamplifier is equip-
ped with a digital coaxial input connector, the
relevant CD player signal output may be connec-
ted to this. It is not necessary to connect an ana-
logue (13) and a digital signal output (14) at the
same time.
Vincent
28
REAR VIEW
14
15. Voltage Selector:
The voltage selector behind the pane allows swit-
ching the voltage from 230 V to 110 V.
Refer to safety instructions for further information (p.
34, "Switching the Voltage")
16. POWER CONTROL (12V): ON/OFF control
These jack connectors (3.5 mm) receive and for-
ward the signal for the standby control (12V
Trigger).
17. AC: Power Connector
To establish the power supply, connect the plugs of
the power cable to the device and to a suitable wall
outlet. The small plastic housing holds the fuse. Refer
to the security precautions.
15
16 17