Abus TVIP41660 Notice D'utilisation page 132

Right: high sensitivity
Left: low sensitivity.
Arming Schedule
To save a schedule for motion-controlled recording, click on "Edit".
A new window appears. Specify here on which days of the week and at which times motion-controlled
recording should take place.
Now select a day of the week for motion-controlled recording. To store particular time periods, enter a
start and end time. To set up all-day motion detection, select 00:00 as the start time and 24:00 as the
end time.
To apply motion detection for all days of the week, click the "Select All" checkbox. To copy motion
detection to other days of the week, select the day of the week and click on "Copy".
To apply the changes, click "OK" and to discard them click "Cancel".
Apply the settings made by clicking "Save".
Link Method
Send email:
Notify Surveillance Centre
Enable recording:
Other Linkage
You can set the alarm output to switch when an alarm is detected.
Click on "Select All" to switch the alarm output.
Apply the settings by clicking "Save".
You receive an email as notification; check the checkbox to activate
this.
If your camera has been set up for this, you can send a notification to
the CMS.
Enables recording to the internal microSD card.
132
English