Safety Recommendations - SKF TMMH 300/500 Mode D'emploi

«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
As the incorrect use of handling tools constitute a potential safety risk,
the following must be considered:
• Only competent personnel must use the equipment. (Competent
personnel as defined according to the statutory regulations
applicable in the relevant country.)
• Always follow these instructions for use.
• The Bearing Handling Tool must only be used for handling non-
separable bearings. It must not be used for handling other types
of workpieces.
• Before use, the Bearing Handling Tool must be inspected for
damage. Do not use damaged tools.
• Check the weight of the bearing to be lifted. Never use the Bearing
Handling Tool for lifting or handling bearings above 500 kg (1100 lbs).
• Personnel using the Bearing Handling Tool must use appropriate
protective or safety equipment at all times (e.g. safety boots and
helmets).
• The bearing must only be lifted as high as the application
requires. The handling action (turning from horizontal to vertical
and vice-versa) with a bearing must always be effected at the
minimum height from the floor as possible.
• Never stand or put your foot under the bearing. Avoid all
hazardous situations of a similar nature.
• Never use the Bearing Handling Tool with accessories (e.g.
slings), which are rated below 500 kg (1100 lbs).
• Do not use chains to lift the Bearing Handling Tool.
• Do not modify the Bearing Handling Tool.
• The Bearing Handling Tool must be periodically inspected
according to local statutory regulations. In case of any uncertainties
as regards the use of the Bearing Handling Tool, contact SKF.
The Bearing Handling Tool must under no circumstances be
used for handling bearings with an oily outer ring. Bearings
with an oily outer ring will slip out of the tool when lifted.
The outer ring must be thoroughly cleaned with a cloth using
solvent or a cleaning agent.
«БЕРГ АБ», (495) 727-22-72, promshop-biz@ya.ru, www.promshop
6

SAFETY RECOMMENDATIONS

Bearing Handling Tool SKF TMMH 300/500 TMMH 500/700