Tascam CD-VT1 Mode D'emploi page 8

Making connections
Adjusting the balance Adjusting the balance
Inputs Inputs
 e  has three input sources  e  has three input sources
 the  being played
 the microphones connected to
the MIC IN jacks
 any stereo input connected to the
LINE IN jack
 e fi rst and last of these cannot have
their input levels changed by the 
 but see below for details of how
to balance the  with the input
 se the level control of the device
connected to LINE IN
level of this source remember that
this source cannot be eff ected by
the s eff ects
 se the s
INPUT
to adjust the level of the micro
phones before they are sent to the
eff ect
 hen a menu is not selected you
can use the and
6 n
the relative balance of the micro
8 8 8
— TASCAM CD-VT1 — TASCAM CD-VT1
The CD plays at a fixed
level, but the MIX
feature (5 and b keys
outside menu mode)
adjusts the balance
betwen input and CD
to adjust the
control
phone inputs but not the
IN source compared to the output
from the  player  is
can be set to between
emember that this is only pos
keys to set
sible when not in menu mode or
when editing eff ects
Use the INPUT
control to adjust the
MIC IN level(s)
Use the OUTPUT
control to adjust
the overall level
to the LINE OUT
and headphones
Outputs
LINE
 ere are two outputs the line and the
value
MIX
headphones  ese cannot have their
and 
–5 +5
levels set separately—use the
control to set the overall output level
You can't adjust the
input level of LINE IN
from the CD-VT1
OUTPUT