Assembly Procedure; Installation Requirements; Fitting Procedure - Quick Totem G TM 600G Manuel De L'utilisateur

BEFORE USING THE CAPSTAN READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING: the Quick
Do not use the equipment for other purposes.
Quick ® shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use of the equip-
ment.
The capstan is not designed for the loads that might occur in extreme weather conditions (storms).
Always deactivate the capstan when not in use.
For improved safety we recommend installing at least two anchor capstan controls in case one is accidentally damaged.
We recommend the use of the Quick
The contactor unit or reversing contactor unit must be installed in a point protected from accidental water contact.
THE PACKAGE CONTAINS: capstan - reversing contactor unit - base gasket - handle - bolts and screws (for assembly) -
drill template - user's manual - conditions of warrant.
TOOLS REQUIRED FOR INSTALLATION: drill and drill bits: Ø 10 mm (13/32"); hexagonal wrench: 13 mm.
"QUICK ® "ACCESSORIES RECOMMENDED: anchoring RL control board (mod. 800) - Waterproof hand helds R/C (mod. HRC1002)
- Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Radio control RRC (mod. R02, P02, H02).

ASSEMBLY PROCEDURE

The following parts are to be checked before the holes are drilled. There must be no obstacles below deck to perform the installation in
the lower part. The thickness of deck must be such as to allow the capstan to be securely placed in position.

FITTING PROCEDURE:

Fix the capstan by screwing the nuts, the grower and the washer onto the fixing screws provided.
Connect the supply cables from the capstan to the reversing contactor unit.
WARNING: before wiring up, be sure the electrical cables are not live.
TOTEM 600/1000/1100 G - REV001A
® capstans are designed to weigh engineered for capstan operation.
® hydraulic-magnetic switch as the motor safety switch.
when the ideal position has been established, drill the holes using the drilling template provided.
® " DEALER.

INSTALLATION REQUIREMENTS

lower surfaces of the deck are as parallel as possible.
If this is not the case, compensate the difference appropriately (a lack of
parallelism could result in a loss of motor power).
The deck thickness must be included among the figures listed in the table.
In cases of other thicknesses it is necessary to consult a Quick
INSTALLATION
:
Ensure that the upper and
GB
® retailer.
11