Removing An Sd Card; Sd Card Memory; Transferring Files; Via Usb Cable - Polaroid Snap Guide De L'utilisateur

images that you'd like to save, as well as
print. To insert a memory card, gently push
the SD card into the slot on the side of
your camera. You'll feel a slight click when
the card is fully inserted and the SD LED
will glow white. Use cards with up to
32GB max capacity.

Removing an SD Card

Give a light push to the top of the card
and the SD card will pop out. Pull to fully
remove from your Snap.
SD Card Memory Indicator
When the memory on your SD card dips
below 1GB the LED on the back of your
12 | EN
Snap will glow red. When the memory
reaches zero, or if there is an error reading
the SD card, the LED will blink red.

Transferring Files

Via USB Cable

– Using the included micro USB cable,
connect your Snap to a computer. Double-
click the SD card when it appears on your
computer desktop to view and save your
images to a photo roll or other location.

Via SD Card

– Remove the SD card per the directions
above then insert the card into your
card reader.
Battery & Charging
When the battery power dips below 10%
the battery LED will glow red. At 2% power,
your camera will automatically shut down.
To charge your Snap, plug it into either a
wall outlet or computer, using the included
micro USB cable. The battery LED will blink
red until the battery is fully charged.

Auto Sleep

To help save battery power, your Snap
will automatically go into sleep mode
after several minutes of no use. To turn
your camera back on, close and re-open
the viewfinder.

Self-Timer

Your Snap comes with a ten-second
self-timer. To set it, press the timer button
(located on the top of the camera), then
press the shutter button. The timer button
will blink white while the timer counts
down and in ten seconds, your photo will
be captured.

Adding Effects

Photo Frames

– To add a Polaroid border to your print,
press the frame button located on top of
your camera.
EN | 13