Maintenance; Preventive Maintenance; Cleaning; General User Information - CombiSteel 7455.2150 Mode D'emploi

4. Maintenance

PRIOR TO ANY CLEANING OR MAINTENANCE PROCEDURE, UNPLUG THE REFRIGERATOR!
WARNING
DO NOT DAMAGE THE REFRIGERANT CIRCUIT.
WARNING
The component parts shall be replaced with like components and that servicing shall be
done by factory authorized service personnel, so as to minimize the risk of possible ignition
WARNING
due to incorrect parts or improper service.

4.1 Preventive maintenance


Clean the condenser once or twice yearly using a vacuum cleaner.

Use mildly soapy water to clean the interior of the refrigerator. Use a window-cleaning agent to clean the
glass surface. Use gloves when you clean the glass.

Pay the appropriate attention during the transportation of the cooler so that you do not damage the
LED/lamp, the front grille or the glass door.
Do not use alcohol/acid based cleaning agents.
WARNING

4.2 Cleaning

Tend the area of the cooler and keep it clean and dry.
It is important to clean the refrigerator twice a year. In order to avoid mould formation, odours, etc. product
compartments must also be thoroughly cleaned. The interior of the refrigerator has to be cleaned with a mild
soapy cloth. Keep the cooler in a stable position during cleaning.
For your safety, during cleaning the unit should be unplugged from the wall socket.
Do not remove the safety devices (grates, guards, earthlings, etc.).
Keep the cooler in a stable position during cleaning, do not step on or lean over the cooler.
If one or more of the bottles break while in the appliance and liquid spills inside the cabinet
WARNING
or the space surrounding the appliance gets wet, unplug the cooler before you clean the
liquid around and inside the cooler. Remember to take all necessary actions to protect
yourselves from broken glass (use protective gloves when cleaning).

4.3 General user information

There are two isolated cabinets for this unit, While right is for freeze and left is for refrigeration.
The right freezer is controlled by an electronic temperature controller which is at the right side of front grille.
The initial setting temperature for controller is -20°C, if you require a higher temperature (warmer) or a lower
temperature (colder), you can follow the below operation:

Press SET for 3s;

When appears St, press SET again;

Increase or decrease the value using

Press SET to confirm the new value
or
7