Connection To The Mains Supply - CombiSteel 7455.2150 Mode D'emploi

Keep the ventilation openings, both in the appliance enclosure and in the built-in structure,
WARNING
clear of obstruction.
Do not use electrical appliances inside the food storage compartments of the appliance,
WARNING
unless recommended by the manufacturer.
Do not use mechanical devices or means other than those recommended by the
WARNING
manufacturer to accelerate the defrosting process.
The instructions for appliances which use flammable insulation blowing gases shall include
WARNING
information regarding the disposal of the appliance.
To reduce the possibility of fire, this appliance must be installed only by a suitably qualified
WARNING
person.
Failure to comply with the instructions may result in high-energy consumption and poor
performance of the unit.
INFORMATION
b) Mains connection: If the mains cord supplied is not long enough, do not use an extension lead. Ask a
technician to install a socket near the refrigerator.
If the supply cord is damaged, it must be replaced by the manufacturer, its service provider
or similarly qualified persons in order to avoid a hazard.
INFORMATION
c) The refrigerator-freezer must stand upright for at least 1 hour after transportation and prior to start up.
d) Ensure that there is a spacer to maintain a distance between the back side of the refrigerator and the wall,
and that nothing is placed on top of the refrigerator.
Do not use electrical appliances inside the cooler.
INFORMATION
e) Allow a minimum gap of 100mm at the rear and 50mm at the sides of the cooler. Assemble the spacer
supplied with the appliance to adjust the correct distance from the rear walls. Do not place anything on top
of the refrigerator.

3.2 Connection to the mains supply

Connect the refrigerator to a 220-240 Volts, 50Hz power supply on a min 10A fused & grounded socket. Do not
use extension cables. If the power cord is not long enough, ask an authorized electrician to replace it with a
longer one, or to install a socket near the refrigerator. Do not compress the main cable.
If the supply cord is damaged, it must be replaced by the manufacturer, its service provider
or similarly qualified persons in order to avoid a hazard.
INFORMATION
6