AEG 7306601 Manuel D'installation Et De Fonctionnement page 61

Step G - Sanitize, Test and Purge System
SANITIZE THE SYSTEM
Sanitizing is recommended immediately after
installation of the Reverse Osmosis system. It's
also recommended after servicing inner parts. It
is important that the person installing or servicing
the system have clean hands while handling
inner parts of the system.
Complete the following steps to sanitize the
system.
See Fig. 21.
1. Make sure that the water supply to the
Reverse Osmosis system is off.
2. Open the Reverse Osmosis faucet. If the tank
is not already empty, allow the water to empty.
3. Locate the eyedropper included in parts bag
and common household bleach (5.25%).
4. Add 3 ml of bleach into open end of yellow
tubing. Handle bleach according to bleach
manufacturer's recommendations. See Fig.
21.
5. Connect yellow tubing to tank connector. See
Figs.11 and 21.
6. Sanitizing the system will be completed
during the pressure test and purging steps on
the following page.
NOTE: The bleach must be removed from the
system before drinking the water. See purging
instructions on the next page.
Eyedropper
(not included)
61
FIG. 21