Step F - Connect Tubes - AEG 7306601 Manuel D'installation Et De Fonctionnement

Osmoseur

Table des Matières

Les langues disponibles

HOW TO CUT AND CONNECT THE TUBES

Your Reverse Osmosis system includes push-in fittings for

quick tubing connection. Review the following instructions

before connecting the tubes in the next step. Failure to

follow these instructions may lead to future leaks.

Cut tubes to length

1. Use a sharp cutter or knife to cut the end of tubing.

2. Always cut the tubing square. See Fig. 15.

3. Inspect the tube up to 2.5 cm from the end to be sure

there are no nicks, scratches or other rough spots. If

needed, cut the tubing again. See Fig. 15.

NOTE: Tubing lengths should allow for the removal of

the assembly from the hanger washers for servicing.

If tubing lengths are shortened for neater appearance,

it may be necessary to keep the assembly on the

hanger washers for service.

Connect tubes

NOTE: Remove protective foam plugs before

connecting tubes (See Fig. 14). Discard foam plugs.

1. Push tubing through collet, until it engages the o-ring.

See Fig. 16. Continue pushing until the tube bottoms

out against the back of the fitting. See Fig. 17. Do

not stop pushing when the tube engages the o-ring.

Failure to follow these instructions may lead to future

leaks. When a 1/4" (6.35 mm) tube is fully engaged,

1.7 cm of the tube has entered the fitting. When a 3/8"

(9.5 mm) tube is fully engaged, 1.9 cm of the tube has

entered the fitting. Mark tube with a piece of tape or

marker. See Figs. 16 & 17.

2. If additional tubing is required, see parts list at the end

of this manual.

To Disconnect Tubes

1. Push the collet inward with a finger tip. See Fig. 19.

2. Continue holding collet inward while pulling the tubing

out. See Fig. 19.

Collet