AEG 7306601 Manuel D'installation Et De Fonctionnement page 60

HOT COLD
Water Supply
Fitting
NOTE: Tube colors
match collet colors.
CONNECT GREEN TUBE TO COLD WATER
SUPPLY PIPE
1. Locate the 1/4» (6.35 mm) green tube.
2. Route one end of the green tube to the water supply
fitting on the cold water pipe. See Fig. 20.
3. Cut tube square. See Fig. 15.
4. Connect to water supply fitting. This is a compression
fitting. Tighten nut securely. See Fig. 5.
5. Route the other end of the green tube to green collet
on the left side of the Reverse Osmosis filter assembly.
6. Cut tube square and to length. See Fig. 15.
7. Insert all the way into the fitting. See Figs. 16 & 17.
8. Pull on the tube to be sure it is held firmly in the fitting.
CONNECT BLUE TUBE TO REVERSE OSMOSIS
FAUCET
1. Locate the 3/8» (9.5 mm) blue tube.
2. Route one end of the blue tube to the RO faucet
connector. See Fig. 20.
3. Cut tube square. See Fig. 15.
4. Insert all the way into the faucet connector push-in
fitting. See Figs. 16 & 17.
5. Route the other end of the blue tube to blue collet on
the right side of the Reverse Osmosis filter assembly.
6. Cut tube square and to length. See Fig. 15.
7. Insert all the way into the fitting. See Figs. 16 & 17.
8. Pull on both ends of the tube to be sure it is held firmly
in the fittings.
Step F - Connect Tubes (cont.)
RO
Faucet
Faucet
Drain
Connector
Adapter
3/8" (9.5 mm)
black tubing
Tubing Union
Sink
P–Trap
NOTE: Tubing lengths should allow for the
removal of the assembly from the hanger
washers for servicing. If tubing lengths are
shortened for neater appearance, it may
be necessary to keep the assembly on the
hanger washers for service.
CONNECT RED AND BLACK TUBES FROM REVERSE
OSMOSIS FILTER TO DRAIN ADAPTER
1. Locate the 1/4" (6.35 mm) red tube attached to the
Reverse Osmosis filter assembly.
2. Route the other end of the red tube to a spot between
the RO filter assembly and the drain point. See Fig.
20.
3. Cut tube square and to length. See Fig. 15.
4. Insert all the way into the appropriate-sized (1/4")
push-in fitting of the tubing union (Fig. 20). See Figs.
16 & 17.
5. Locate the 3/8" (9.5 mm) black tube.
6. Cut one end of tube square and insert all the way into
the 3/8" push-in fitting of the tubing union. See Figs.
16 & 17.
7. Route the other end of the black tube to the drain
adapter (Fig. 20). Cut this tube as needed to route it
as straight as possible, without loops, dips, or kinks.
8. Insert all the way into the drain adapter's push-in
fitting. See Figs. 16 & 17.
9. Pull on both ends of the tubes to be sure they are held
firmly in the fittings.
ROUTE YELLOW TUBE TO STORAGE TANK
1. Locate the 3/8" (9.5 mm) yellow tube attached to the
Reverse Osmosis filter assembly.
2. Route the loose end of the yellow tube to the fitting on
top of the storage tank. See Fig. 20.
3. Cut tube square and to length. See Fig. 15.
4. Do not connect at this time. This will occur in the
sanitizing step (next page).
60
Tank Connector
FIG. 20