Step D - Install Storage Tank - AEG 7306601 Manuel D'installation Et De Fonctionnement

Osmoseur

Table des Matières

Les langues disponibles

INSTALL REVERSE OSMOSIS FILTER ASSEMBLY

The Reverse Osmosis Filter Assembly is mounted on

hanger washers.

See Fig 10. The hanger washers allow you to lift the

filter assembly from the washers without any hardware

removal. When planning your installation, you need to

leave room for changing filters.

Complete the following steps to install your Reverse

Osmosis Filter Assembly:

1. Remove the cover.

2. Locate mounting slots on back inside of the assembly.

See Fig 10.

3. Hold the assembly up to the wall surface and mark

locations for the hanger washers. See Fig 10. Mount the

unit high enough to allow room to change filters without

taking the unit off of the wall.

4. Fasten the hanger washers to the wall using the wood

screws provided.

5. Hang assembly on washers.

6. Replace cover.

The fitting on the supply tank may need to be tightened

7-8 full turns to get a good seal.

Do not overtighten.

INSTALL STORAGE TANK

1. Apply of thread sealing tape (2 wraps clockwise) to

the threads on the nipple at the top of the tank. See

Fig 11.

2. Locate the tubing connector. See Fig. 11. Tighten the

tubing connector onto the tank nipple 7-8 full turns,

being careful not to cross thread or overtighten.

3. Do not connect the tube at this time. This will occur

later in the assembly.

4. Place the storage tank next to the Reverse Osmosis

Assembly. The tank can be placed upright or on its

side.

Step C: Install RO Filter Assembly