Signal Menu - Sony VPL-VW100 Mode D'emploi

Signal Menu

The Signal menu is used to adjust the input signal. You can adjust the size of
the picture, and select wide screen mode, etc.
.
Adjust Signal
You can adjust the input signal.
Dot Phase
H Size
Shift
Wide Mode
You can set the aspect ratio of the picture to be displayed for the current input
signal. This item is enabled only when an SD signal (preset memory numbers
1 to 6) is input.
Full
Normal
Wide Zoom
Zoom
Subtitle
Adjust Signal menu
Picture
Signal
Function
Installation
Setup
Information
Adjusts the dot phase of the panel and the computer signal.
Adjust the picture to the point where it looks clearest.
Adjusts the horizontal size of the picture from a computer.
The higher the setting, the wider the picture. The lower the setting,
the narrower the picture.
Adjust the setting to match the number of dots of the input signal.
Adjusts the position of the picture.
H: As the setting for H (horizontal) increases, the picture moves to
the right, and as the setting decreases, the picture moves to the left.
Use < or , to adjust the horizontal position.
V: As the setting for V (vertical) increases, the picture moves up,
and as the setting decreases, the picture moves down. Use M or m to
adjust the vertical position.
A picture squeezed to 4:3 is displayed with the correct aspect.
A 4:3 aspect ratio picture is displayed to fill the vertical screen
height.
A 4:3 aspect ratio picture is enlarged and the upper and lower
portions are compressed to fit the 16:9 screen.
A 4:3 aspect ratio picture is enlarged vertically and horizontally
at the appropriate ratio to fill the 16:9 screen.
The subtitle area is compressed and displayed at the lower part
of the screen.
Adjust Signal
Dot Phase : 24
H Size : 1344
Shift : H:204 V:34
Sel: Set: Back: Exit:
Signal Menu
47
GB