Sony VPL-VW100 Mode D'emploi page 65

8
Insert the new lamp unit straight
in all the way until it is securely in
place and you hear it click.
Notes
• Insert the new lamp unit while holding it
tightly, because it is heavy (approx.
2.9 kg (6 lb 6 oz)). Dropping the lamp
may result in an injury.
• Be careful not to touch the fan or optical
block inside the unit.
• Confirm that the lamp release lever has
returned to its original position. If not,
the projector will not turn on.
9
Tighten the four screws loosened
in step 6 to secure the lamp unit to
the projector.
10
Tighten the screw loosened in
step 4 to close the lamp cover.
11
Close the top cover.
12
Connect the power cord and set
the projector to standby mode.
Confirm that the ON/STANDBY
indicator is lit in red.
13
Pointing the remote control at the
projector, press the following
buttons on the remote control in
the following order for less than
five seconds each: RESET, <,
,, ENTER.
Caution
Do not put your hands into the lamp
replacement slot, and do not allow any liquid
or other objects into the slot to avoid
electrical shock or fire.
Notes
• Be sure to use an LMP-H400 Projector Lamp
for replacement. If you use lamps other than
the LMP-H400, the projector may
malfunction.
• Be sure to turn off the projector and unplug
the power cord before replacing the lamp.
Replacing the Lamp
65
GB