Changing Side Of The Belt Clip; Charging The Battery Pack [4]; Charger Wall Mount - Festool CXS Li 1.5 Guide D'utilisation

Changing side of the belt clip

Fix the belt clip [3-1] on the right or on the left side,
depending on which side you prefer to clip the cord-
less drill.

Remove the battery pack [2].

Remove the belt clip [3-1].

Insert the belt clip on the designated side.

Insert the battery pack [2].

Charging the battery pack [4]


To charge the battery pack, put it on the retainer
[4-1] on the charger.

To remove, press and hold the button [4-2] and
pull off the charged battery pack.
The LED [4-3] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Charging battery pack at maxi-
mum rate.
LED green - flashing slowly
Charging battery pack to 80% and
with reduced current.
LED green - lit continuously
Charging process is charged.
LED red - flashing
General fault indicator, e.g.
incomplete contact, short circuit,
defective battery pack, etc.
12
3
4-1
3-1
The charger MXC has two elongated holes on its
back. It can be mounted on a wall using two screws
(e.g. round head or flat head screw with shank di-
ameter of 5 mm) (see Fig. [5]).
5
3 mm
LED red - lit continuously
Battery temperature is outside
permissible limit values (0 °C to
55 °C).
klick
1
1
2

Charger wall mount

5mm
85 mm
11
(3 / ")
32
Do not attach to
inclined wall!
4
4-2
4-3