Further Information; Guarantee; Ec Declaration Of Conformity - Birchmeier RPD 15 PB1 Mode D'emploi

VII Further Information

1. Guarantee

• Prerequisite to the honouring of warranties is the appropriate storage and use of our equipment strictly in
accordance with the operating instructions which were valid on delivery (including the instructions given on
the appliances themselves). These instructions constitute an integral part of our contract. Any and all
damages which fall within our scope of responsibility must be reported to us in writing immediately after
they have been discovered.
• Expressly excluded from the warranty and liability are damages and deficiencies:
- Resulting from the non-adherence to our instructions and usage recommendations in the operating
manuals, such as the improper use or inadequate maintenance of our equipment; resulting from
chemical attack, or due to normal wear;
- Due to damages, the causes of which are beyond the scope of our responsibility and influence, e.g.
mechanical damage, force majeure.
• The warranty becomes null and void, and all liabilities are disclaimed if the user or any third party alters or
makes inexpert repairs to the sprayer.
• Excluded from the warranty and liability are all incidents which extend beyond the obligations set forth
above. Any and all liability is expressly excluded to the extent of the law. Expressly excluded is in
particular, any and all liability for damages which are purely asset-related such as lost profit, loss of use,
operating outage etc.
Place of jurisdiction:
Applicable law:
• For any further information concerning use or maintenance of the equipment please refer to your dealer.

2. EC Declaration of Conformity

We Birchmeier Sprühtechnik AG
Im Stetterfeld 1
CH 5608 Stetten
hereby confirm that the sprayers
Model: RPD 15 PB1
RPD 15 PB2
described below conform to the relevant fundamental safety and health requirements of the appropriate EU
Directives both in its basic design and construction as well as in the version marketed by us.
Relevant EC Directives:
2009/127/EC EC Machinery Directive
Harmonised standards applied:
EN 12100:2010
Appropriate internal measures have been taken to ensure that series-production units conform at all times to
the requirements of current EU Directives and relevant standards.
The signatory is empowered to represent and act on behalf of the company management.
Stetten, 15.09.2017
M. Zaugg
Head of Development & Engineering
Baden, Switzerland
Swiss law
Item No: 11952501
11969501
- 21 -