Basic Functions - Birchmeier RPD 15 PB1 Mode D'emploi

2. Basic functions

Changing position
Pull the pump lever out at the pump-lever joint to the first catch (adjustment position). Turn the pump lever to
the desired position and slide it back in again until it's completely locked into position.
Disassembling the pump lever
Release the hose from the connecting rod, pull the pump-lever joint out to the first stop, turn to the assembly
position (pump lever has an angle of approx. 45°) and pull out completely.
Changing the pump lever side
Quick-release axle
Snap-in hooks
Pump-lever joint
Connecting
rod
Union nut
Warning: Do not twist the cylinder.
When reassembling, pay close attention to
the direction.
- 18 -
Shaft
Cylinder
Loosen the union nut and pull the pump-lever
Joint, together with the connecting rod and the
piston, out of the cylinder.
Remove the pump-lever joint. Turn the
connecting rod and piston unit 180° and mount
the pump-lever joint again.
Cylinder
Press the snap-in hooks
together and pull the
shaft out from the
quick-release axle.