Replacement Parts And Wearing Parts; Problems / Solutions - Beurer EM 70 Mode D'emploi

• If replacement electrodes are necessary, use only electrodes that
are the same as the electrodes provided with the EM70.
• Always use electrodes with CE mark.
• Always clean the electrodes after your treatment every time.
Storing the electrode pads
Place clean, dry pads on the plastic film and then store in the sealed
package between uses.
Storing the unit
Place the unit, electrodes and manual back in package. Store the
box in a dry place, 14°F~131°F (-10°C~55°C); 10% ~90% relative
humidity.
KEEP DEVICE AND ALL ACCESSORIES OUT OF REACH OF
CHILDREN.
CAUTION
• Store the device in the dry, clean place. Do not expose the device
to any chemical solvent, water, lint, direct sunshine or high tem-
perature.

11. Replacement parts and wearing parts

You can obtain the following replacement parts directly from Cus-
tomer Services:
Designation
Adhesive electrode set:
2 x Electrode pad (50*50mm)
1 x Electrode pad (110*70mm)
1 x Electrode pad (190*95mm)
Item number and/or order
number
Item No. 648.22

12. Problems / solutions

Problem Possible causes
The unit can not Are the batteries
power on. exhausted?
Stimulation weak Electrodes dried out
or cannot feel or dirty.
any stimulation.
Electrodes cannot
stick skin well.
Stimulation is Intensity is too high.
uncomfortable.
Electrodes are too
close together.
Electrode active ar-
ea size is too small.
Is the device being
operated according
to the manual.
Stimulation is Improper electrode
ineffective. placement.
Unknown.
The skin becomes Use the electrodes
red and/or you feel on the same site
a stabbing pain. every time.
The electrodes are
not adhered to the
skin properly.
35
Possible solution
Charging.
Replace new
electrodes.
Reconnect the
electrodes.
Decrease intensity.
Reposition the
electrodes.
Use the larger elec-
trode pad included
in delivery.
Please check the
manual before use.
Reposition
electrode.
Contact clinician.
Re-position the
electrodes. If at any
time you feel pain or
discomfort stop use
immediately.
Ensure the elec-
trodes are securely
adhered to the skin.