Allen-Bradley 931S-C2R1D-DC2R Notice D'utilisation page 4

3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
2
3.2 Opening the unit
Disconnect the plugs. Disengage the top part of
the housing by carefully pressing the latches on
both sides (1). Pull out the top part of the hou-
1
1
sing and the electronics section until they lock
(2).
3.3 Settings
Low trip, high trip, FAILSAFE or NON FAILSAFE
are set via the DIP switch. SW1 in accordance with
the following tables. The hysteresis and the signal
threshold can be set via the potentiometer
SW1
positioned below the cover (3) at the front of the
module.
3
Signal threshold
Hysteresis
2